Nu Calgon Easy Seal Ultimate Large System 4050-07 2 to 10 Tons(Bulk 6 Pack)

Description

Nu Calgon Easy Seal Ultimate Large System 4050-07 2 to 10 Tons(Bulk 6 Pack)
Nu Calgons Easy Seal Ultimate for Large Systems Treats Systems 2 to 10 Tons. number 4050-07.
Six (6) Sealers Included.
The EasySeal line has proven to be the number one trusted leak sealant brand for years, with millions of leaks sealed. Now Nu-Calgon has made EasySeal even better with EASYSEAL ULTIMATE  the strongest and fastest leak sealant on the market, now with the ability to treat systems up to 10 tons in one application!
Permanently seals Micro even larger leaks
Rapid Fusion Technology for a stronger bond
Easiest to install direct inject
Works with all refrigerants
Treats larger systems
OEM Approved Not to Clog Manifold Gages
No Additional Tools Needed
Perfect for MicroChannel Coils
Proven Not To Plug TXV's or Pistons
No Need to Pump Down the System
Each Package is Individualy Sealed
This product must be used in accordance to the following directions by HVACR professionals only.
Make sure system is running and low side and high side service ports are properly identified. If unit is a heat pump, be sure it is in cooling mode. Connect EasySeal Ultimates female fitting to the suction service port of system. The one way check valve will prevent back flow of refrigerant.
Make sure both valves on manifold gauge set are closed. Connect highside (red) line of manifold gauge set to the high side service port. Barely thread the middle manifold hose (yellow) to the male fitting of the EasySeal Ultimate. Do not thread to the point of depressing the Schrader core. Briefly crack open high side manifold valve to purge air out of the yellow hose, close high side manifold valve, then quickly tighten yellow hose fitting to the injector.
Briefly open then close high side valve of the manifold gauge set to allow a little high side liquid to flow through the yellow hose and EasySeal Ultimate tube. With high side valve of the manifold gauge set closed, wait one minute for the yellow hose and EasySeal Ultimate to equalize to suction pressure. Disconnect EasySeal Ultimate from suction service port and from manifold gauge set. Discard or recycle empty injector.
NOTE:
You may also use a refrigerant cylinder to push sealant into system while charging if the system is low on refrigerant. Just connect EasySeal Ultimate to service port and inject refrigerant through injector into system while charging.
WARNING:
Wear safety glasses. Do not bend, cut or deform EasySeal Ultimate tube.
Product Details
Brand
Nu-Calgon
Manufacturer
Nu-Calgon
Product Type
EasySeal Ultimate
Mpn
4050-07
Nu-Calgon part number 4050-07
Easy Seal Ultimate for Large Systems
Treats Systems 2 to 10 Tons
Six (6) Sealers Included.
Check out my other items.
-
Powered by